Step 1: Disconnecting Motors

• Hold the airframe while simultaneously holding down the PCB using the thumb and middle finger

• Using the tweezers, firmly grab the end of the motor wire closest to the port and detach it by pulling upwards away from the PCB (perpendicular to the PCB)

• Lastly, pull the motor wire out of the airframe channel

• Repeat this process for all [4] motors

Note: When removing the Motor Connection Wire from the PCB, it is important to remember to pull UPWARDS, perpendicular to and away from the PCB.​ DO NOT pull parallel to the PCB - this will most likely damage the terminal on the PCB, rendering the PCB useless.

Step 2: PCB Removal

• Now that the PCB is disconnected, you may remove it from the airframe

• As you remove the PCB touch as little as possible, and store in its sealable bag until the next use